Setting up the BASE

Tell the base what rover to broadcast to

Use the command
ATS53=xxx.xxx.xxx.xxx/p
Where xxx.xxx.xxx.xxx is the IP address of the rover, this is required.
P is the port number, it just need to be the same as used in the rover
 

Enable Rs-232 to internet conversion

use the command
ATS50=1
to reduce the time to make a packet.

Set into listen mode

Use the command
ATS83=2
to set the modem into listen mode.

Ignore flow control

Use the command
ATS211=2
to assume DTR.
 

Set the default power up mode

Use the command
ATMD3
To set the default mode on power up

 

Save the changes so they are used on power up

Use
AT&W
To save the settings

Now when he base is turned on it will automatically send data to the rover, the CMR output must already be enabled. If the base modem does not get data for 30 seconds it needs to be powered off and restarted

[Home] [Trimble] [Basic Setup] [Phones] [Cables] [Troubleshooting] [Types] [US Carriers] [Internet Links]