The system performs a number of tests.

The following features are checked for

1. Normal Dialing
2. Dialling without DTR
3. Dial without DTR after &D0 has been sent
4. Receiving Welcome message when RTS is low
5. Receiving Welcome message when RTS is low, after sending \Q0
6. Receiving Welcome message when RTS is low, after sending &K0
7. Receiving Welcome message when RTS is low, after sending &H0 &R1
8. &B1 support, locked baud rate
9. The phone must support E0 for the savings settings test
10. Phone is detected by sending V1, (alphanumeric responses)
11. The phone is hung up using AT H0 (Normally)
12. DTR is ignored using &D0 and &D2 (normal)
13. CTS follows CD using &S5 also &S0 (CTS normal)

[Home] [Trimble] [Basic Setup] [Phones] [Cables] [Troubleshooting] [Types] [US Carriers] [Internet Links]